Description

Specification:Power Voltage: DC 6~12V Interface: DC 5.0Voltage measure range: 0~150V, Accuracy 0.05VCurrent adjustable range: 0~10A, Accuracy: 0.05ACapacity range: 0~999.999Ah, Accuracy: 0.001AhCumulative range: 0~99999.9Wh, Accuracy: 0.01WhMeasure range: 0~2999.9W, Accuracy: 0.01WImpedance range: 0~999.9Omega, Accuracy: 0.01OmegaTemperature range: 0~99℃, Accuracy: 1℃Max timing: 999:59:59 Accuracy: 1sFan cooling power: <150WFan control threshold: Temp>40℃Standby reminder threshold: <2W/0.5hTiming function: >0.5W start timingInput interface: 20A high current occlusion screw column, USB type A, Mini USB, Micro USB, Type-CRefresh time: >500ms/timeMeasurement rate: 0.5time/sOver limit alarm: interface warning and buzzer alarmVoltage overrun auto- stops discharge range: 0~150VCurrent overrun auto- stops discharge range: 0~10APower overrun auto- stops discharge range: 0~150WDisplay screen: LCM displaySize: 149*96*80mm/195*105*135mm(package)Weight: 570g(package)/370g(net weight)Consumption: <1.5AOperating temp: -10~60℃Operating humidity: 10~80%RH(No condensation)Mode button function:1. Click to switch each display interface2. The function of the button operation in the 2-4 interface is as follows:①long press all records to clear②Double-click capacity (Ah) to reset to zero③three-stroke power (Wh) reset to zero④four-stroke power (00:00:00) reset to zero⑤consecutive seven hits at no load, making the current zero accurate in the current temperature environment. Calibration is zeroed for accurate measurement at low currents. Factory reset all parameters.3. The operation functions of the buttons under the interfaces 6, 7, 9, 11, and 13 are as follows:①Double-click the parameter value to increase, double-click and long press the parameter to continue to increase②The value of the three-stroke parameter is reduced, and the length of the three-stroke is continued to decrease.Usage:1. Input voltage * current le 150W2. Turn on the load power supply, and the coarse and fine adjustment knobs will be reset to zero (counterclockwise to the end)3. Long press the mode button to clear all data4. Connect to the power supply under test, and use the fine adjustment knob to slowly adjust the discharge current.When the fine adjustment cannot meet the current value, the fine adjustment is reset to zero, and the coarse adjustment knob is slowly adjusted.And with fine adjustment until the required current value is reached.5. It is recommended to set the cutoff voltage (lower voltage input) when the battery is discharged.In order to avoid damage caused by excessive discharge.A: Power supplyB: Fan power supplyC: BuzzerD: Input terminalE: Input interfaceF: Mode buttonG: USB inputH: Mini USB inputI: Type-C USB inputJ: Mirco USB inputK: Minor debugging Rotary KnobL: Rough debugging Rotary KnobM: Transmission InterfaceN: FanO: LCM DisplayNote:1. Before use, two current adjustment knobs need to return to zero counterclockwise. If it does not return to zero, connected voltage too high,  the load may be burned directly if it exceeds 150W.2. When connecting to the test power supply adjustment, it must be adjusted slowly, because it is an analog device, maybe the display does not respond quickly, and the load may be burned if the power is exceeded.Package Included:1 x Electronic load host1 x Power Adapter(US OR EU)1 x Instruction manual