Description

Features:

USB dual meter is small in size

It can display USB charging or discharging voltage and current at the same time and on the same screen, alternately or single display capacity and power

Adopt USB extension cable input, output at both ends, easy to use

The USB double meter adopts exquisite SMT craftsmanship, so the consistency is very good

Built-in intelligent charging identification IC, which can automatically match high current charging

Product parameters：

Product name: USB test table

Display mode: 0.28"LED, single color (full red), two colors (red and blue) color optional

Product size: 69×26×19mm

USB extension cable: ≥120mm

Measurement accuracy: 0.1% (±3 digits)

Measurement rate: ≥500mS/time

Working temperature: -10～+65℃

Working air pressure: 80～106kPa

Working humidity: 10～80% (no condensation)

Sun exposure: no direct sunlight

Input voltage Test voltage: 3.20-30.0V (automatic shift of decimal point) Resolution below 10V: 0.01V Resolution above 10V: 0.1V

Test current: 0.00-3.00A (up to 10A, can not work for a long time) Resolution: 0.01A

Automatic identification: OUTPUT Ⅱ has built-in intelligent charging control IC, which can automatically match your mobile phone and tablet with suitable and safe high-current charging

QC2.0 QC3.0: OUTPUTI supports Qualcomm QC2.0, QC3.0 charging (Note, when using QC2.0, QC3.0 charging, OUTPUT II cannot be plugged into other devices)

Capacity test: 0-99999mA/H (ie 99.999A/H)

Capacity accumulation: in the case of uninterrupted power, the accumulation of N times of charging capacity

Capacity check: 1. Power on without connecting any USB device, the displayed capacity is the last accumulated capacity, and the accumulated capacity has a power-off memory function

2. After the power-on capacity is cleared, the displayed capacity is the accumulated capacity of the current N times of charging or discharging.

3. You can switch to view by pressing the button

Capacity reset: 1. When the power is turned on and recharged after a power failure, the last accumulated capacity will be reset by "flash twice"

2. Long press the button to accumulate capacity and the accumulated capacity will be reset by "flash twice"

Power test: 0.00-9.99-99.9W, the decimal point is automatically shifted

Overvoltage alarm: when the voltage is >/=5.6V, the voltage decimal point - flashes quickly

Undervoltage alarm: when the voltage is </=4.4V, the voltage decimal point - flashes slowly

Overcurrent alarm: when the current >/=3A, the current decimal point - flashes quickly

Short circuit alarm: current decimal point - flash quickly

Button: One button, you can switch 7 different display modes: only VA, only C, and only P—VA+C—VA+P—C+P—VA+C+P, long press the button to clear the accumulated capacity alarm When prompted, you can long press the button to cancel the alarm prompt function

Shipping list:

USB Tester X1