Description

Description:

L293D is a monolithic integrated, high voltage, high current, 4-channel driver.

Basically, this means using this chip you can use DC motors and power supplies of up to 36 Volts, that's some pretty big motors, and the chip can supply a maximum current of 600mA

per channel, the L293D chip is also what's known as a type of H-Bridge.

The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.

Feature:

* Interface:2

* Support Reset button

* Run motors: 4.5V to 36V DC

* Can drive 4 DC motors or 2 stepper motors or 2 Servo

* 4 H-Bridges: per bridge provides 0.6A(1.2A peak current)

* Pull down resistors to keep motors disabled during power-up

* Up to 4 bi-directional DC motors with individual 8-bit speed selection

* Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil, or interleaved stepping

* 2 interfaces for 5V Servo connected to the original board's high-resolution dedicated timer - no jitter

Notes:

Due to the difference between different monitors, the picture may not reflect the actual color of the item.