20x20mm Skystars F405 Mini HD2 Flight Controller and KM35 35A 3-6S ESC Stack with Barometer for Betaflight and INAV RC Drone FPV Racing

Note - This stack supports M2 and M3 screws both use appropriate Rubber Gummies supplied as per your need.

Orange Rubber - M3

Red Rubber - M2

What makes this FC different from others?

1. Solder pads are the largest in size compared to other FC in market.

2. Proper solder pad spacing to avoid solder bridge and facilitate easy soldering.

3. ESC connector on top-side rather than bottom which makes it easy for repair.

4. Hybrid design allows both M3 and M2 screw.

5. TVS Diode for Reverse Polarity Protection and Voltage Spike Suppression.

6. Powerful BEC to supply all your electronics.

7. Pads arrangement are executed in such a way that when you twist the wires of the camera VTX and RX you don't get any wire overlapping this gives you a uniform twist and clean look.

8. DJI connector on the bottom side.

9. Budget-friendly price ( We understand the situation of chip shortage and rising prices of FC )

10. Two stages of Quality check to reduce any faulty electronic.

11. No power lines near Gyro to avoid any EMI interference.

12. Comes ready with I2C support and INAV.

Specifications:

Item name: F405HD2 Mini Betaflight Flight Controller

Input voltage: 3-6S LiPo(11.1V~22.2V)

MCU:STM32F405RGT6 168MHz

IMU: MPU6000 (SPI)

OSD: Betaflight OSD &DJI HD OSD (UART6)

6 hardware UARTS (UART1,2,3,4,5,6,)

Receiver:TBS/PPM/SBUS/IBUS/DSM

Barometer: YES

Buzzer Pad: YES

CURR Pad: YES

BEC 5V 2A & 10V 2A(Max 3A)

Blackbox: 16MB

Firmware: Betaflight /INAV SKYSTARS F405HD

Mounting Holes: 20mm/M2 or M3

Weight: 4.8g

Item name: KM35 35A 4IN1 ESC

Input voltage: 3-6S LiPo

Con.Current: 35A

Peak Current:45A 10S

Firmware: BLHeli_S

Support : Dshot 300/600

Mounting holes : 20X20 mm/M3

BEC: No

Product size: 31*36*3.9mm

Weight: 7.8g

Includes

1x F405HD2 Mini Betaflight Flight Controller

1x Skystars Kramam 35A 3-6S 20x20 4in1 ESC