Description

Specification: Motor Drive Module Operating mode: H-bridge driver (dual) Chip: L298N Logic voltage: 5V Logic current 0mA-36mA Drive voltage: 5V-35V Drive current: 2A (MAX single bridge) Maximum power: 25W Dimensions: 43x43x27mm Note: General Application: When your driver is 7V-12V (Marked as 12V Input), you can use the on-board 5V logic supply. When using the on-board 5V power supply, do not input voltage at interface 5V Input, but it can draw 5V voltage for external use. Unconventional application of high-voltage drive: When the driving voltage is higher than 12V, less than or equal to 24V. First, the onboard 5V output enabled jumper cap must be removed, and then connect the 5V external voltage to the 5V Input interface to power the L298N internal logic circuit. DC Motor Operating Voltage: 3V ~ 6V DC Reduction ratio: 1:48 When the voltage is 6V: No-load current: ≤200mA No-load speed: 200±10%rpm When the voltage 3V: No-load current: ≤150mA No-load speed: 90±10%rpm Product List: 4 x Smart Car Wheel 4 x DC Motor 2 x L298N Motor Drive Controller Board 20 x 20CM Jumer Wire female to female 20 x 20CM Jumer Wire Male to Male 20 x 20CM Jumer Wire Male to Female