3000W Solar Power Grid Tie Inverter with Limiter Function

String Inverter DC 100V-500V input Voltage. AC 160V-300V Single Phase output Voltage . Power Limiter Function : selectable Wi-Fi Function : Yes (need wifi port )

Leading Features:

1. Max Efficiency of 97.5% and wide input range. 2. Single MPPT design with accurate MPPT algorithm. 3. Intelligent cooling, IP65 protection. 4. Compact and light design for easy Installation. 5. Transformerless GT topology. 6. RS485, WiFi Interface. 7. Numerous protection functions. 8. Optional build in Anti-Overflow function. 9. 7 years standard warranty, 25 years lifespan design.

Photovoltaic Grid-connected System

Appearance Introduction

Single Phase String Power Inverter can convert solar panel DC power into AC power which can directly input to the grid. Its appearance is shown below.These models contain SUN-1K-G、SUN-2K-G and SUN-3K-G . The following is collectively referred to as‘inverter’.

Limiter function wiring diagram

When you are reading this, we believe that you have completed the connection according to the requirements of chapter 5, if you has been running your inverter at this time, and you want to use the limiter function, please turn off AC and DC switch of the inverter, and wait for 5 minutes until the inverter completely discharged. Then connect the current sensor to the inverter limiter interface.Make sure they are reliably connected, and the current sensor should clamp to the live wire of the incoming line.In order to make it easier for you to use the built-in limiter function of the inverter, we have specifically given the wiring diagram,as shown in Picture 7.1, the red lines connected to the utility grid said wire (L), blue line shows the zero line (N), yellow green line shows the ground wire (PE). We recommend installing a AC switch between the inverter outlet and the utility grid, the specs of the AC switch is determined according to the load capacity. The AC switch we recommend to connect to the inverter output can refer to Table 5.1.If there is no integrated DC switch inside the inverter you purchased, were commend you to connect the DC switch. The voltage and current of the switch depends on the PV array you access.