• small but complete

• Mature infrared technology

• Multiple(3)sensing points

• No separate controller

• With protective cover

• Auto calculation of added amount(5mm)

• Auto shutdown when there is water shortage or water level is abnormal

• Fool operation

• Maximum Flow 280L/H

• Power 4W

• Voltage:110V-240V  DC 12V

Set-up Directions:

• Install the probe with a water level lower than the probe or in the middle of the probe

• Plug in the power supply first, then plug in the pump

• The system will automatically add water to the high level sensing point

• Let the water level below the low level sensing point to see if the system will automatically add back the water

Notice:

• If you quickly lower the water level or pick up the probe during the test,it may be caused by residual water droplets on the probe.as long as the probe is cleaned, it will return to normal

• Protective cover must be installed

• The water outlet should not be aligned with the probe

• If you unplug the power supply and still add water,it is siphoning.you need to open a hole with a diameter of 1mm on the water pipe.after opening the hole,water will flow out the hole and flow back into the bucket when the pump is running.this is normal,after the pump stops working, the small hole will draw in air and destory the siphon

Package included:

• Power supply

• 2m water pipe

• High lift(2m)miro water pump

• Mini water pipe holer(<=16mm glass)

• Mini probe(Controller built-in)