DC 5V/12V/24V High Level PNP Signal Trigger Relay Switch 0-999 Counter Accumulator Signal Detector Monitor 0.1S-999M Delay Time

1.Description:CT1.1 is a DC 12V 24V Dual Timer Module Trigger Delay MOS Controller Programmable Independent Controller.Its maximum count value is 999. When it reaches the set count value, the output state of the relay can be changed, or the output state can be changed after a delay.2.Features:1>.Programmable timer and counter2>.High level signal trigger3>.Parameter power-off save3.Parameters:1>.Product name:CT1.1 DC 12V Counter Accumulator2>.Work voltage:DC 12V3>.Work current:18mA4>.Delay time: 0.1s~999m6>.Trigger signal:High level trigger signal7>.Output type:Relay switch(No voltage output)8>.Load:DC30V/10A or AC250V/10A(Max)9>.Work Temperature:-25℃~85℃10>.Work Humidity:5%~95%RH11>.PCB Size:51*40*22mm4.Function:1>.Counter:1.1>.This mode needs to set 3 parameters: Count value, ON/OFF default initial state, Signal refresh interval.1.2>.Press SET button to set count value. Its set range is 000~999.Then press ENTER button to set parameter value.1.3>.Then press SET button select the next parameter and set value.1.4>.ON/OFF default initial state: ‘-ON’ relay default states is ON which means relay will turn to OFF from ON state after reach count value. ‘-OF’ relay default states is OFF.1.5>.dL0~dL9:Counting sensitivity. dL9 means refresh and scan the input port every 0.09 seconds.2>.Timer:2.1>.This mode needs to set 2 parameters: ON/OFF default initial state and delay time.2.2>.Keep press SET button more than 3second to set timer.2.3>. ON/OFF default initial state: ‘t ON’ means relay output is ON status when delay time at T. ‘t OF’ means relay output is OFF status when delay time at T.2.4>.Delay time T : Press SET button to set value from 000 to 999. Keep press SET about 3 second to switch time unit.‘99.9’ means 99.9 seconds. ‘999’ means 999 seconds. ‘999.’ means 999 minutes.2.5>.Reset:Press two buttons at the same time, then turn on the power. it means the reset is successful if it displays ‘rst’, and all parameters are restored to factory settings.2.6>.Keep press SET button more than 5second enter into set mode at normal display status.2.7>.It means that the setting is completed and the parameters are saved when no bit flashes.3>.E.g:The relay turn ON for 0.1 second every 99 counts:3.1>.Press SET to set count value as 099.3.2>.Press SET to set ON/OFF default initial state as ‘-OF’.3.3>.After automatically save parameters(No bit flashing), Keep press SET button more than 3second to set ON/OFF default initial state as ‘t ON’.3.4>.Press SET to set delay time as 001.

5.Application:1>.Industrial control equipment2>.Signal detector3>.Instrumentation test4>.Experimental data testing and monitoring