ENCHEN POP CLEAN, ULTRA-FAST AUTOMATIC SOAP DISPENSER

The ENCHEN Automatic Induction Soap Dispenser with sensitive infrared sensor fast foams out with non-contact use methods, good for kids and adults using at home, office or school. So small and simple that you can put it at anywhere.

WASH YOUR HANDS WITH THE RIGHT AMOUNT OF SOAP

The best thing about this type of soap dispenser is that it releases just the right amount of gel, yet produces a lot of foam. This makes it enough to wash your hands properly, without wasting so much product and leaving no residue after you rinse. Its design comes with a capacity of 280 millilitres and has two modes (one dispenses more gel and another less).

AUTOMATIC INDUCTION SOAP DISPENSER WITH SMART LASER

Enchen POP CLEAN has an automatic dispensing system, the most important element of which is the intelligent laser sensor. You will only have to bring your hands a few centimetres closer and, only 25 seconds later, you will have the gel in your hands — Non-contact washing hands!

COMPACT & MINIMALIST DESIGN

Designed along the brand's classic lines and features a beautiful, minimalist white design. In short, it will go unnoticed wherever you place it, practically becoming part of the decoration.

Maintenance method

Remove the botte and open the cap,and pour warm wator below 40℃Cinto the bote(Warm water at about 40℃ hs abotteroffect on dssolving the sticky stuffin pipes)Put the iquid botte back on the machine and start using it as usual until water comes out of the foamoutlet. Repeat 10-15times for better results.1.Remove the botte;2.Open the cap, and pour warm wator below 40°C into the bottle;3.Put the liquid bottle back on the machine and start using it as usual until water comes out of the foam outlet.Repeat 10-15 times for better results.

Instructions:

Warm reminder: Please dry the water stains before touching the switch, so as not to cause the switch failure. It is normal to find a small amount of liquid in the dispenser, which is left after the factory test!1. Touch the top button to turn on / off;2.The blue breathing light lights up once when the dispenser is turned on, which is at the SMAL mode;3.Continue to press the button,the white breathing light lights up once for the LARGEmode;4. When sensing, the breathing light at the top will be on to indicate foam dispensing and the amount of dispensation; 5. Red light flashes when low battery;6.After the dispenser is turned on,it can be keptin standby state for about 90 days without shutting down, based on the daily usage of 10 times.Wish you a happy use!

Maintenance:

1.If you need to clean, it is recommended to use a wet towel to gently wipe the surface of the foam soap dispenser when it is turned off. 2. If this product is left unused for a long time,please remove the battery to prevent the battery from moisture, leakage and other phenomena. 3.If you purchase a soap-flled model, the soap residue in the dispenser may cause blockage.Please take water out about every 3 months to clean the dispenser so as to make the product to have a longer service life and better use.

Precaution:

1.Do not place this product in water or rinse it with water directly to avoid short circuit.2.Do not tilt the bottle when installing or replacing foam soap. It is normal that a small amount of liquid flows out,and the dispenser can still be used normally after wiping it clean.3.Store this product in a cool place away from direct sunlight or heat sources.

Automatic Foam Soap Dispenser

This product is suitable for any brand of foam soap. Please dilute it by 2-6 times of water according to the concentration and shake it before use. Precautions: Children should(play)use under the supervision of adults to prevent them from touching soap into the eyes and eating it by mistake!