Description

Specification: Brand new Input Voltage Range: 5~32VDC(Note: input voltage not exceeding 32V) Output Voltage Range: 0.8-30VDC adjustable Output Current: 0-5A(adjustable) High Efficiency: up to 95% Input reverse polarity protection: None(if required, high current diode in series with the input). The size is Length 51.2mm Width 26.2mm Height 15mm Feature: Built in thermal shutdown function, current limit function, output short protection function. Fine workmanship and good performance. High efficiency. Easy to use. Long service life. As a Battery Charger Module without constant function can not be used to charge the battery, because the complete consumption of battery charger great pressure, leading the charge current is too large, causing damage to the battery, so when the battery begins to use a constant current charging when the charge to a certain extent, when to automatically switch back to the constant voltage charging. Usage: 1. Make sure you need to charge the battery float voltage and charging current. 2. Adjust the constant voltage potentiometer to adjust the output voltage to about 5V. 3. Use the multimeter (10A) to measure the short circuit current and adjust the constant current potentiometer to make the output current reach the predetermined charge current value. 4. Recharge the light current by default to 0.1 times the charge current (constant current value). 5. To adjust the output voltage of the constant voltage potentiometer to float voltage. 6. battery, test charge. (1, 2, 3, 4, 5 steps for module input power supply, output no-load non battery.) Use as a normal buck modules with over-current protection capabilities 1. Determine that you need to drive the LED's working current. 2. Adjust the constant voltage potentiometer to adjust the output voltage to about 5V. 3. Use the multimeter(10A)current gauge to measure the short circuit current, and adjust the constant current potentiometer to make the output current reach the predetermined LED working current. 4. Constant voltage potentiometer makes the output voltage reach LED.high working voltage. 5. LED test machine. (1, 2, 3, 4 steps for module input power supply,output no-load no LED lamp.) This module is more than 5A in use, to enhance heat dissipation. Package included: 1 x DC Buck Converter