Description

Ethernet RJ45 TCP/IP remote control board with built-in 8 channel relays 250VAC 485 network controller with enclosure

Product selling point:

1. Using high-quality materials, the quality is guaranteed

2. Ethernet TCP/IP RJ45 port

3.Onbacord WEB server allows you to access and control relays via WEB

4.8 250V/AC 10A independent control relays

5. With plastic shell, it is safe and convenient to use

1: Trigger signal input

There are two input methods for IN1-IN8: A: Non-contact signal, release after IN is grounded

B: Latch signal, IN grounding can control the corresponding relay switch

2: Serial communication protocol

1 way open: FD 02 20 01 01 5D

1 way off: FD 02 20 01 00 5D

2 way open: FD 02 20 02 01 5D

2 way off: FD 02 20 02 00 5D

3 way open: FD 02 20 03 01 5D

3 way off: FD 02 20 03 00 5D,

4 way open: FD 02 20 04 01 5D

4 way off: FD 02 20 04 00 5D

5 way open: FD 02 20 05 01 5D

5 way off: FD 02 20 05 00 5D

6 way open: FD 02 20 06 01 5D

6 way off: FD 02 20 06 00 5D

7 way open: FD 02 20 07 01 5D

7 way off: FD 02 20 07 00 5D

8 way open: FD 02 20 08 01 5D

8 way off: FD 02 20 08 00 5D

1-8 way open: FD 02 20 F8 88 5D

Road 1-8: FD 02 20 F8 80 5D

Back: FB 21 55 xx XX FF : xx XX eac byte means 1ch high byte corresponding to the 16ch, low byte corresponding to 1ch

3: Controller interface IP: 192.168.1.4 Port number: 30000

Enter http://192.168.1.4/30000 in the address bar of the browser, and then you can control the corresponding switch.

4 Press and hold "RESET" until the light goes out. Restore the factory default IP and port number.

Shipping list:

8-channel integrated relay remote control board X1