It is used for PLC output load current amplification and isolation protection. It is installed at the digital output end of controllers such as PLC, single chip microcomputer Industrial Control Board, time relay, buttons, etc. to amplify the control current at the output end.
It is used to load high-power equipment, weak current control strong current and other occasions to protect the core control system from damage.
(1)1 set of independent relay modules
(2) built-in RJ2S electromagnetic relay with 8A2250VAC(RES) load capacity
8A30VDC(RES.) has CCC, TUV, UL and other certifications.
(3) input mode: terminal block input, NPN and PNP are common, AC and DC are common.
(4) output form: 2 normally open and 2 normally closed.
(5) it has each set of independent LED working status indicators and surge suppression protection loops.
(6) the output has overvoltage protection.
(7) bottom TS15/28/35 rail installation.
Technical parameters
Input operating voltage
Rated voltage DC/AC ± 10%
Relay installation
Plug-in type
Rated load current
8A250VAC/30VDC
Maximum instantaneous load current
8A
Classic input current under Un
6.5MA
Un under the classic corresponding time
0.5MS
Un classic release time
15 ms
Input/Output connection mode
Screw connection
Suitable for cables
0.2 ~ 2.5mm²
Stripping length
6-7mm
Mounting rail size
15/28/35mm
Net weight test pressure resistance
2.5KV,50Hz, 1 min
Ambient temperature range
-20 ° C ~ 50 ° C
Power consumption
0.53W
Overall design
Professional circuit design, with short circuit, anti-interference, output overvoltage or overcurrent protection circuit, safe and reliable advanced production using wave soldering, clean and elegant appearance and ensure product quality.
