Description
Total flowmeterHeight: 136mm
InterfaceCenter distance: 116mm
InterfaceOuter diameter: 8mm (connection leather tube inner diameter 8mm)
It can also be replaced with quick connector direct plug (please inform the outer diameter of the pipe as shown in the following figure)
RatedWorking pressure: ≤ 0.2MPa (2kg)
Medium temperature:-20~120 degrees
Accuracy level: Level 4
Specification model: LZB-10 glass rotameter
Flow-rate range:0.25-2.5m3/h
Tested medium: air, gas
Accuracy level: 2.5
Connection form: hose connection installation
Measured medium temperature:-20-120 ℃
Measured medium pressure: ≤ 1MPA
Brief introduction: glass rotor flowmeter (hereinafter referred to as flowmeter) is mainly used in chemical industry, petroleum, light industry, medicine, chemical fertilizer, chemical fiber, food, dye, paper making, environmental protection and scientific research departments are used to measure unidirectional non-pulsating flow. Corrosion-resistant flowmeter is mainly used for measuring corrosive liquid, gas medium, etc. It is used to detect strong acid (except hydrofluoric acid), strong alkali, oxidant, strong oxidative acids, single-phase non-pulsating flow rate of organic solvents and other corrosive gases or liquid media. Glass rotameter, diameter 4, diameter 6, diameter 10 are connected by hose, diameter 15-diameter 100 is flange connection, in which 25-diameter 100 with guide rod. LZB-F type anti-corrosion flowmeter, the base material with diameter of 4, 6, and 10 is 1 Crl8Ni9Ti, the upper and lower sealing pricing material is rubber, the anti-corrosion diaphragm pricing material is F46, and the hose connection is also used. The diameter of the LZB-F-type anti-corrosion flowmeter is 15-100, which mainly consists of glass Taper Pipe, plastic-coated floater, Bushing, upper and lower base, upper and lower stop, support plate, front and rear cover, sealing ring and sealing ring diaphragm, etc, corrosion-resistant flow meters are connected by flanges (flanges are specified in JB78-59 cast iron flanges), and their appearance and installation dimensions are shown in the table. LZB-F-type corrosion-resistant flow meters with diameter of floater and diameter of 100 are all provided with guide rods to make the floater move stably and protect the Taper Pipe from being damaged. The corrosion-resistant flowmeter uses advanced anti-corrosion materials in contact with the medium, leiteng PPS Resin and fluoroplastic F46, and the exterior surface is made of epoxy anti-corrosion paint and amino baking paint as protective materials, so it has good corrosion resistance, it is reliable and effective in the flow measurement of various corrosive media strong acids (except hydrofluoric acid) strong bases, oxidants, strong oxidative acids organic solvents and other corrosive gases and liquids.
LZB-4 ~ 80 main technical indicators
|
Model
|
Nominal diameter Dg(mm)
|
Measuring range
|
Accuracy level
|
Taper Pipe length (mm)
|
Working pressure (Mpa)
|
Floater material
|
|
Measurement ratio
|
Liquid
|
Gas Gas
|
|
LZB-4
|
φ4
|
1:10
|
1～10 L/h 1.6～16 " 2.5～25 "
|
16～160 L/h 25～250 " 40～400 "
|
2.5 1.5
|
160
|
≤1
|
Lr11 Aluminum Lr11 Aluminum Stainless steel Stainless steel
|
|
LZB-6
|
φ6
|
2.5～25 " 4～40 " 6～60 "
|
40～400 " 60～600 " 100～1000"
|
|
LZB-10
|
φ10
|
6～60 " 10～100 " 16～160 "
|
100～1000 " 160～1600 " 250～2500 "
|
|
LZB-15
|
φ15
|
16～160 " 25～250 " 40～400 "
|
250～2500 " 400～4000 " 600～6000 "
|
1.5 2.5
|
350
|
≤0.6
|
|
LZB-25
|
φ25
|
40～400 " 60～600 " 100～1000 "
|
1～10 m3/h 1.6～16 " 2.5～25 "
|
1.5
|
|
Model
|
Nominal diameter Dg(mm)
|
Measuring range
|
Accuracy level
|
Taper Pipe length (mm)
|
Working pressure (Mpa)
|
Floater material
|
|
Measurement ratio
|
Liquid
|
Gas
|
|
LZB-40
|
φ40
|
1:10 1:5
|
160～1600 L/h 250～2500 "
|
4～40 m3/h 6～60 "
|
1.5 2.5
|
430
|
0.6
|
Stainless steel Stainless steel
Lr11 Aluminum Lr11 Aluminum
|
|
LZB-50
|
φ50
|
400～4000 " 600～6000 "
|
10～100 " 16～160 "
|
450
|
0.6
|
|
LZB-80
|
φ80
|
1～10 m3/h 1.6～16 "
|
50～250 " 80～400 "
|
Brief introduction: glass rotor flowmeter (hereinafter referred to as flowmeter) is mainly used in chemical industry, petroleum, light industry, medicine, chemical fertilizer, chemical fiber, food, dye, paper making, environmental protection and scientific research departments are used to measure unidirectional non-pulsating flow. Corrosion-resistant flowmeter is mainly used for measuring corrosive liquid, gas medium, etc. It is used to detect strong acid (except hydrofluoric acid), strong alkali, oxidant, strong oxidative acids, single-phase non-pulsating flow rate of organic solvents and other corrosive gases or liquid media. Glass rotameter, diameter 4, diameter 6, diameter 10 are connected by hose, diameter 15-diameter 100 is flange connection, in which 25-diameter 100 with guide rod. LZB-F type anti-corrosion flowmeter, the base material with diameter of 4, 6, and 10 is 1 Crl8Ni9Ti, the upper and lower sealing pricing material is rubber, the anti-corrosion diaphragm pricing material is F46, and the hose connection is also used. The diameter of the LZB-F-type anti-corrosion flowmeter is 15-100, which mainly consists of glass Taper Pipe, plastic-coated floater, Bushing, upper and lower base, upper and lower stop, support plate, front and rear cover, sealing ring and sealing ring diaphragm, etc, corrosion-resistant flow meters are connected by flanges (flanges are specified in JB78-59 cast iron flanges), and their appearance and installation dimensions are shown in the table. LZB-F-type corrosion-resistant flow meters with diameter of floater and diameter of 100 are all provided with guide rods to make the floater move stably and protect the Taper Pipe from being damaged. The corrosion-resistant flowmeter uses advanced anti-corrosion materials in contact with the medium, leiteng PPS Resin and fluoroplastic F46, and the exterior surface is made of epoxy anti-corrosion paint and amino baking paint as protective materials, so it has good corrosion resistance, reliable and effective in the flow measurement of various corrosive media strong acids (except hydrofluoric acid) strong bases, oxidants, strong oxidative acids organic solvents and other corrosive gases and liquids
