Description

● Do you come across following troubles?

During daytime, people look at the house when passing by?

Harmful UV rays make the furniture fade and hurt your skin?

Because of the direct and strong glare, the room gets hot and you need to pay higher electricity bill?

● How will the black one way mirror film help to deal with these problems?

During daytime, you can get great privacy protection because people outside can't see through the window of mirror effect.

This reflective mirror film can block out 98% UV rays and 85% infrared rays, which helps to protect the furniture and people.

With the rejection of 90% visible light, it can soften the strong sunlight and keep the room cool.

● What features does this reflective window cling have?

Magical Mirror Effect: The one way mirror window cling features the mirror effect on the brighter side. In the Daytime, it's on the outside window to provide privacy, while it's reversed at night.

UV Rejection&Glare Control: It can reflect most of UV rays and strong sunlight back to protect you and block out heat.

Easy Installation: It's more easily to apply the film on the window. It becomes non-sticky after being wet with lots of water. After dried up, it would stick strongly to the window.

Comfortable&Economical: Anti UV and Anti Glare

No worries about the hot strong sunlight! The one way window film can block up to most of the harmful UV rays and infrared rays, also visible light. It helps to prevent furniture fading and save your energy bills.

Privacy Matters: Mirror Effect and Daytime Privacy

In the daytime, when the exterior light is stronger than the interior light, the outside glass will show mirror effect. Therefore, people are not able to see in, and your home privacy is then ensured with a great view of the outside scenery sitting at home.

Glare Control and Add Comfort

Annoying glare on TVs and computers? Our one-way films can help you work effectively and relax comfortably by significantly reducing eye strain and discomfort from excessive light

Holding Shattered Glass

When the window accidentally breaks, our one-way film can provide a strong force to fix the glass fragments together to prevent splashing and accidental injury

Installation Instructions:

• 1. Measure the surface and cut the film. Leave an extra inch margin on each side for an easy adjustment.

• 2. Clean the target surface thoroughly and make sure the surface is clean enough without any dust.

• 3.Peel off the transparent backing film along a short side.

• 4.Spray a lot of water both on the adhesive side and window surface(Very Important!!!), then apply the film to the window.

• 5. use a squeegee to flatten the film gently and squeeze out bubbles little by little.

• 6. Trim off the margins and use a cloth to flatten out the film. Here you go!

***Note: please spray a super lot of water during installation, which is the key to success.

Some Warm Tips:

1. The window film can only suitable for flat, smooth and clean glass. Most important is to make sure that your window is thoroughly clean, every little speck of dirt may create a bubble;

2. Do not pull the backing off the window film until you are absolutely ready to use the film. Dust may cause the film difficult to stick. As you peel the backing off, do so smoothly and slowly as to not cause any creases. Bubbles you can get out, creases you may can not;

3. When applying the film, please cover all the glass surface to avoid light leakage. This may cause the glass to crack after being unevenly heated;

4. Please do not use the window film if the temperature difference between indoor and outdoor is large (it is recommended that the temperature difference be controlled at about 30 degrees); Do not use laminated glass.