Description:

The transmitter supports Learning Code(1527) Common Chip, such as, PT1527, EV1527, etc. Compatible with the most of 1527 Remote Control Relay Receiver Panel.

4-channel universal decoding module: RX480E-4

The maximum number of different remote controls can be learned and stored: 24.

Up to seven function options:

1. Jog

2. Self-locking

3. Interlock

4. Two-way self-locking + two-way jog.

5. Two-way self-locking + two-way interlocking.

6. Two-way jog + two-way interlock.

7. Two-way interlock + two-way interlock.

Features:

The latest anti-lost code self-recovery function solves the trouble of losing code.

The latest anti-interference software intervenes to prevent accidental startup

Widely compatible, PT2262, PT2260, EV1527, PT2240, etc.

Ultra-wide pulse width range: Oscillation resistance from 105 to 515 is available

In jog mode: support combination code

In self-locking mode: support combination code

In interlock mode: 4 independent opening and closing, combination code all closing

In combination mode, the two channels are independent and do not affect each other.

Clear:

Press the learn code button 8 times, and the LED goes out. After about 3 seconds, the LED flashes 3 times, clearing OK.

Learn to code:

Press the learning button on the board, the LED will light up, and release the learning button to enter the learning code matching mode.

Press any key on the remote control, the LED flashes 3 times, the learning process is OK, and the system automatically exits the learning mode.

If there is no remote control signal after entering the learning code matching mode, it will automatically exit the learning code matching mode after 10 seconds.

1. Self-locking:

Press the same remote control button, press it once, the relay turns on, and press it again, the relay turns off.

2. Interlock:

Press the remote control "A" button, the relay will open,

Press the "B" button on the remote control to turn off the relay.

3. Jog:

Press the remote control "A" button to turn on the relay, and release the remote control "A" button to turn off the relay.

If you keep pressing the "A" button of the remote control, the relay will always be on. When you release the remote control, the relay will be off.

Explanation about the purpose of the output signal of LED:

When any button of the remote control is pressed, the receiving end decodes, and after correct decoding, the LED will output a high level signal

1. When the remote control button is released, the LED output becomes 0. That is: only when the reception is valid and decoded correctly, it will be output.

Specifications:

Material: Metal and PVC.

Product Type: Learning Code (1527) Remote Control Key Fob.

RF Frequency: 433 MHz.

Channel Supported: Four Channel.

Encoding Type: Learning Code(1527).

Modulation System: ASK.

Operating Voltage: DC 12V.

Operating Current: