SCN-800-24 paraller function 800W full input range 24V 33A high efficiency switching power supply

Category : Home Improvement | Electrical Equipment & Supplies

USD 123.12USD 129.60

SCN-800-24 paraller function 800W full input range 24V 33A high efficiency switching power supply

Description
Specification

Description

SPECIFICATIONS
OUTPUT
MODEL	SCN-800-12	SCN-800-15	SCN-800-24	SCN-800-48
DC Voltage	12V	15V	24V	48V
Rated Current	66A	54A	33A	16.6A
Current Range	0-66A	0-54A	0-33A	0-16.6A
Rated Power	800W	800W	800W	800W
Ripple & Noise	150mVp-p	150mVp-p	240mVp-p	480mVp-p
Voltage Adj. Range	±5%; Can adjust from 40%~100% output voltage by external control 2-5V
Voltage Tolerance	±1%	±1%	±1%	±1%
Setup, Rise, Hold Up Time	800ms, 50ms, 16ms at full load

INPUT
Voltage Range	90~130VAC/180~260VAC selected by switch 47~63Hz; 260~370VDC
AC Current	13A/115VAC 8.0A/230VAC
Efficiency	80%	81%	85%	87%
Inrush Current	60A/230V
Leakage Current	3.5mA/240VAC

PROTECTION
Over Load	110%~135%
	Protection: Protection: Current limiting, delay shut down o/p voltage, re-power on to recover
Over Voltage	110%~135%
	Protection type: Shut down o/p voltage, re-power on to recover
Over Temp	TSW1 (Power transistor) When temp. >100℃, shut down o/p voltage, re-power on to recover

ENVIRONMENT
Working Temp., Humidity	-10℃~+65℃; 20%~90%RH
Storage Temp., Humidity	-20℃~+85℃; 10%~95%RH
Vibration	10~200Hz, 2G 10min./1cycle, period for 60min, each along X, Y, Z axes

SAFETY
Withstand Voltage	I/P-O/P, I/P-FG:1500VAC
Isolation Resistance	I/P-O/P, I/P-FG, >100M Ohms / 500VDC

STANDARD
Safety Standard	Design refer to UL1950,CSA22.2,IEC60950
EMC Standard	Design refer to FCC Part 15 Class A

OTHERS
Dimension	29113268mm(LWH)
Weight	2.57Kg
Packing	6pcs/15.42kg/CARTON

NOTE

1.All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1μ & 47μ parallel capacitor.

3. Tolerance: includes set up tolerance, line regulation and load regulation.

4. The power supply is considered a component which will be installed into final equipment. The final equipment must be re-confirmed that it still meets EMC directives.