ST-LINK V2 Simulator Download Programmer Original STM32F103C8T6 ARM STM32 Minimum System Development Board STM32F401 STM32F411
l WARNING: STM32 chips run on 3.3V, most breakout boards will include a voltage regulator so it can be powered from USB, and STLink dongles will provide a3.3V VCC pin to power up the chip.
l Do not connect the board to the PC using USB while the chip is powered up usingthe ST-Link V2 programmer!
l Connect one or another but not both simultaneously. The ST-Link V2 dongle provides a 5V pin as well. It is not going to be used because the STM32 chips are not5V tolerant, the 3.3V pin has to be used only.
STM32F411CEU6 core board 128KB RAM 512KB ROM
1. 25MHZ high speed crystal oscillator & 32.768Khz 6PF low speed crystal oscillator
2. Flash pads are reserved, providing USBDisk&&FATFFS routines
3. Jumper cap can be used directly without installation.BOOT0 internal 10K resistance pull-down
4. Factory has burned breathing lamp &&USBCDC test procedures.
5. Provide available MicroPython firmware, configuration files
6. Adjust the direction of the jumping cap if it cannot be installed.Because the jump cap is wide on one side and narrow on the other.
7. V1.3 board with 3 buttons: reset key, BOOT0 key and user button.
V1.3 serial download and DFU download: connect to PA9 and PA10 (connect to usb in DFU mode) by pressing BOOT0 key and reset key, and then release the reset key. After 0.5 seconds, release the BOOT0 key to enter serial download or DFU download. The corresponding software is flymcu or CubeProg.
Jump cap version download: BOOT0 connect to high, BOOT1 connect to high, enter the serial port to download or DFU download, the software is the same as above.
is_customized : Yes
Model Number : STM32F103C8T6 / STM32F103C6T6
Operating Temperature : STM32F401 STM32F411 STM32F4
Dissipation Power : ST-Link V2 / STM32F103C8T6
Origin : Mainland China
Brand Name : CRIMP
Application : Computer
Supply Voltage : STM32F401 STM32F411 STM32F4
Condition : New
Package : SOP
Type : Voltage Regulator