Description

Touch Switch Capacitive Module 5V-24V 3A LED Dimming Control Lamps Active Components Short Distance Scan Sweep Hand Human Sensor

Description：

1. It can penetrate plastic, acrylic, glass, ceramics, and other non-metallic media, with stable performance!

2. Wide range of applications: table lamps, clip lamps, book lamps, aromatherapy lamps, air purifiers, electronic photo albums, small household appliances, KTV VOD systems, automotive systems and other electrical appliances.

3. It adopts a wide voltage working scheme, and the input voltage can be from 3V to 24V.

4. Good anti-interference and adaptive ability.

5. Simple to use and easy to operate.

Parameter:

Output form: dual output

Induction principle: capacitive

Delay closing time: none

Load current: 3A optional

Working voltage: input: 3-24V, output: 3-24V

Induction range: 2-10MM adjustable

Load power: 36W

Scope of application: DC, constant voltage

Standby current: 10mA VIN: 12V

Type 1:

Without the brightness memory, the sudden and dark LED touch stepless dimming function is as follows:

¾ When initially powered on, the light is off.

¾ When you click touch (the touch duration is less than 550ms), the light can be controlled on and off. One click touch, the light is on;

Click the touch again, the light goes out. So cycle. When the light is on or off, there is no brightness buffer. And the light is on

The brightness is fixed at 90% of full brightness.

¾ Long press the touch (the touch duration is greater than 550ms) to realize the stepless brightness adjustment of the light. One long press to touch, light

The brightness of the light gradually increases. When the light is released, the brightness of the light stops at the corresponding brightness at the time of release. If the long press time exceeds 3 seconds, the

The brightness of the light does not change after reaching the maximum brightness; long press the touch again, the brightness of the light gradually decreases, and the light is bright when you release it

The brightness stops at the brightness corresponding to the moment of release. If the long press time exceeds 3 seconds, the brightness of the light will not change after reaching the minimum brightness.

change. So cycle. Tap to touch and long-press to touch can be used at any time without interference and restriction of mutual functions.

Type 2:

Without brightness memory, the LED touch stepless dimming function:

It is based on the LED touch stepless dimming function without brightness memory, when the light is turned on and off by clicking the touch, the light will slowly and smoothly transition from a lower brightness to the initial brightness when the light is turned on. When you tap the touch to turn off the light, the light will slowly and smoothly decrease from the current brightness until it turns off, so as to achieve a slower brightness.

The slow-changing visual buffer effect protects the eyes and vision.

Type 3:

LED touch stepless dimming function with brightness memory gradually brightening and dimming:

The LED touch stepless dimming function with brightness memory fades brighter and fades, and the LED touch stepless dimming function does not have brightness memory fades brighter and fades.

Luminance memory function is added on the basis of light function. That is, when the AC220V power supply is uninterrupted, the light will be turned off every time you click the touch

The brightness at the time will be memorized, and the brightness will be used as the initial brightness the next time you tap the touch to turn on the light. In the case of AC220V power failure

In this case, the initial brightness is fixed at 50% of the full brightness for the first time after the power is turned on.

Type 4:

LED three-segment touch dimming function

¾ When initially powered on, the light is off.

¾ Each time you tap the touch, the brightness of the light will change cyclically in order of low brightness -> medium two degrees -> high brightness -> off.

Package included:

Touch dimming module*1