Product Description:1. The wind turbine can be controlled to automatically charge the battery2. Modular design, so that the performance of the whole system is guaranteed to the greatest extent3. The fully sealed and completely waterproof design is adopted, and the protection level has reached IP67 or above.4. Using MPPT boost charging technology, it can be started when the breeze is low and the energy is sufficient, which can solve the problem that the fan speed is slow and cannot be charged.Precautions:1. Confirm that the output voltage of the wind turbine is consistent with the rate voltage of the battery.2. Wire in the following order, first connect the positive and negative poles of the battery and then connect the three-phase voltage output of the fan.3. Please connect the battery and wind turbine to the controller strictly according to the instructions. Reverse polarity or wrong connection will cause the system to work abnormally and even cause the controller to be completely damaged.Parameters： 1、Maximum input AC voltage: AC35V;2、Output DC voltage: DC12V / 24V;3、Battery charging cut-off voltage: DC14.5V ± 0.3V / 29V ± 0.3V;4、Maximum charging current: 15A (12V) maximum charging current: 10A (24V);5、Wind driven generator speed limit voltage DC14.5V ± 0.3V, 29V ± 0.3V;6、Protection level: IP67;7、Static power consumption: 0.008A;8、Bearing power: 400W;9、Maximum bearing wind speed: lvl.12;10、Working temperature: -35 ° C - 65 ° C11、Input wiring: three-wire system;12、Control mode: 12V/24V compatible;13、Installation method: bolted;14、Wiring is shown in the schematic figure; do not reverse the positive and negative poles to avoid burning the controller.Product List:Wind Turbine Controller*1