Description:The Platform Cable USB ,a USB compatible cable for in-circuit configuration and programming of all Xilinx devices.It derives all operating power from the hub port controller. No external power supply is required. A sustained slave-serial FPGA configuration transfer rate of 24 Mb/s is possible in a Hi-Speed USB environment.Performance:Using CY7C68013A+XC2C256 solution, fully compatible with the original XILINX Platform Cable USBSupports all Xilinx devices, FPGA configuration and PROM/CPLD programmingSupports JTAG, Slave-Serial and SPIInterfaces to devices operating at 5V (TTL), 3.3V (LVCMOS), 2.5V, 1.8V and 1.5VSelectable target clock frequency, supports software automatic frequency adjustmentSupported on Windows and Red Hat Enterprise LinuxAutomatically senses and adapts to target I/O voltageLED Status IndicatorTarget clock speeds are selectable from 750 kHz to 24 MHz.Supported SoftwareXilinx ISE 8 to ISE 14.7 and up-to-date ISE softwareXilinx VivadoIMPACTChipScopeMicroblaze embedded processor debuggingSupported Device:All Xilinx devices, FPGA and PROM/CPLD:All Virtex-FPGA familiesAll Spartan-FPGA familiesXC9500 / XC9500XL / XC9500XV CPLDsCoolRunnerXPLA3 / CoolRunner-II CPLDsXC18V00 ISP PROMsPlatform Flash XCF00S/XCF00P/XL PROMsXC4000 series FPGAsFresh Xilinx devices including V7, Z7 etc.Package Included:1 * Platform Cable USB1 * JTAG adapter1 * USB 2.0 cable1 * 8-pin to 7-pin separated robin cable1 * 14-pin (2.5mm pitch) JTAG flat cable1 * 14-pin (2mm pitch) JTAG flat cable1 * 10-pin (2.5mm pitch) JTAG flat cable