Description

Features:

*1. It is compatible with Citroen cars including: C1, C2, C3, C4, C6, C8, C-CROSSER, NEMO, BERLINGO, JUMPY, JUMPER, AX, SAXO, BX and so on

*2. It is compatible with most Peugeot cars since 1995.

*3. Diagnostics is performed via OBD-II connector (which is located near steering wheel) or via manufacturer-specific connector (only older cars, pre-2001).

*4. Its interface contains K-Line multiplexor, CAN-BUS interfaces and SAE J1850 bus (both PWM and VPW).

*5. It is updated by CD and it supports multi-language.

*6. Diagnostics is performed via OBD-II connector or via manufacturer-specific connector (only older cars, pre-2001).

Functions:

*1. Read Identification. Displays complete identification of control unit, e.g. part number, software/hardware version, manufacturer, etc...

*2. Read Fault Codes. Displays all stored and pending fault codes with complete description (e.g. "Rail pressure - too low pressure").

The program supports report printing or copies to the clipboard.

*3. Clear Fault Codes. This function clears all stored fault codes and other diagnostic information.

*4. Auto-Scan (Complete Car Scan/Test). Detects all ECUs (electronic control units) installed in car and reads all diagnostic fault codes.

*5. Measured Values. Program displays live Data like Engine Speed, Battery voltage, Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in graph, 9 values at once, or full listing (all measured values). Logging to file is also supported, which allows offline analysis.

*6. Actuator Test. Actuator test activates particular actuator (e.g. turn on fuel pump, lock/unlock wheel, lock/unlock doors, cut off fuel, etc..)

Notice: 

Software requires at least Intel Celeron/Pentium III 400 MHz, 128 MB RAM, 50MB free HDD space and USB 1.1 port (USB 2.0 recommended) and Microsoft Windows 98 SR2/2000/XP with the latest service pack installed.

Package Includes:

1 x Main Unit with Extension OBD2 Cable

1 x Long 9pin to USB cable

1 x Short 9pin to USB cable

1 x Instruction